Black and Decker BWDS Manual De Instrucciones página 16

SET UP & USE
Position 3T (DRYER SUPPORT BAR) so the holes at the end are positioned
underneath the screw slots in the back of 8R (RIGHT DRYER SUPPORT) and 8L
(LEFT DRYER SUPPORT). Insert 20SD (20mm SHORT, LARGE DIAMETER SCREW)
through 8R (RIGHT DRYER SUPPORT) and then through 3T (DRYER SUPPORT
BAR). Insert 20SD (20mm SHORT, LARGE DIAMETER SCREW) through 8L (LEFT
DRYER SUPPORT) and then through 3T (DRYER SUPPORT BAR).
NOTE: Follow the same steps to assemble the other 3T (DRYER SUPPORT BAR) in
the front screw holes. Make sure to position the support bars and insert screws
as shown in the diagrams.
20SD
Page 16
8L
20SD
20SD
3T
20SD
3T
20SD
3T
Bottom view
Top view
3T
8R