Black and Decker BWDS Manual De Instrucciones página 8

SET UP & USE
Line up the 2 holes of 1R (RIGHT BASE SUPPORT) with the right side of 1F (FRONT
BASE). Insert 20S (20mm SHORT SCREW) through the screw hole on the exterior
side of 1F (FRONT BASE) until firmly secured into 1R (RIGHT BASE).
Line up the 2 holes of 1L (LEFT BASE) with the left side of 1F (FRONT BASE). Insert
20S (20mm SHORT SCREW) through the screw hole on the exterior side of 1F
(FRONT BASE) until firmly secured into 1L (LEFT BASE)
Remove the backing from the (6) NON-SLIP PADS SMALL (1.6" x .6").
Place the sticky side on the base of the unit as shown in the diagram.
1L
20S
1F
#1
#2
#3
Page 8
20S
SMALL ADHESIVE
NON-SLIP PADS x6
1R
#4
#5
#6