Publicidad
Idiomas disponibles
Idiomas disponibles
SET UP & USE
Tools Required: Screwdriver and Drill (not included)
NOTE:
20S = 4 short 20mm screws.
Used for installing the front base support to the side base rails. Must be inserted so
that the screw head is in on the interior side front base.
20SD = 4 short 20mm large diameter screws. Used for 3T dryer support bars. Must
be inserted from the top of the dryer supports.
25S = 6 short 25mm screws
Used for installing the dryer support to the upper vertical poles and the side support
rails to the lower vertical poles. Must be inserted so that the screw head is in on the
exterior of the unit.
35M = 12 medium 35mm screws. Connects diagonal support rails, side rails and
connecting rails to the vertical poles and installs the vertical poles to the base. Must
be inserted so that the screw head is in on the exterior of the unit.
40LD= 4 long 40mm screws. Only used when installing the BCED15 Dryer (sold
separately). Used for connecting the BCED15 dryer to the dryer support bars. Must
be inserted though the bottom of the dryer support bar. These screws will not be
necessary for larger size dryer connection.
45L = 6 long 45mm screws. Used to connect vertical poles to reinforcing bars. Must
be inserted through vertical rail first then tightened into Reinforcing Bars.
NOTE: It is important to use the correct screw and insert in the location as directed in
the instructions.
To install the screws, use the included wrench or screwdriver (not included). Insert
and turn to the right until the entire threaded part of the screw is fully inserted.
Page 4
Publicidad
