Kobalt KST 2180-06 Manual Del Usuario página 14

ASSEMBLY INSTRUCTIONS
To Install the cutting line
Note: For 0.095 in. (2.4 mm) nylon line, do not
put more than 23 feet (7 m) of cutting line in at
a time.
4d. Line up the slots on the spool cover (M) with the
slots on the spool housing (R).
4e. Insert line through the eyelet. Push line until it
exits the opposite string head hole.
4f. Pull the line through until there is an equal
amount of line on each side.
4g. Push and turn the spool cover (M) clockwise to
wind the string into the string head (J). Leave
approximately 5 inches (13 mm) of string
protruding out of each side of the head.
4d
M
R
4e
4f
4g
M
J
14
Slots