Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING AND MAINTENANCE MANUAL
SWITCHMATIC 2T SERIES CONTROLLER
PUSH BUTTONS
9. START-UP (DIAGRAM C)
Before starting the appliance, read the sections two previous ones, especially "Hy-
draulic Installation" and "Connection electric."
1. In the SW2T model, enter the nominal voltage of the pump:
- Press
for 3 seconds.
- We see the voltage setpoint in V on the screen flashing and the V LED lights up.
- Using the and keys,
adjusted. See Note 2.
2.- Press
to validate.
2. Enter the nominal current of the pump:
- Press
for 3 seconds.
- We see the current setpoint in A flashing on the screen and LED A lights up.
- Using the and keys
adjusted. See Note 1.
- Press
to validate.
www.proindecsa.com / proindecsa@proindecsa.com
PULSATION
From ON state: device OFF.
From OFF state: the device starts and the pump is
activated until Pstop.
From any of the configuration modes:
validates the entered value.
From ON state: device OFF.
From OFF state: the device remains in
runs until the button is released.
We display Pstart for 3 seconds.
We enter the Pstart configuration.
We display Pstop for 3 seconds.
We enter the Pstop configuration.
We display the instantaneous current consumed on
the screen. If we are already seeing it, we see the
pressure again.
We enter the introduction of the maximum nominal
current of the pump.
We display the instantaneous voltage on the screen.
We adjust the nominal voltage between different
options: 110V, 125V, 220V, 230,V 380,V 400V
and
the nominal voltage reflected on the nameplate will be
and
, the nominal intensity reflected on the nameplate will be
ACTION
17
Publicidad
