Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING AND MAINTENANCE MANUAL
SWITCHMATIC 2T SERIES CONTROLLER
IT
TYPE
2.1
r.01 r.99
4
Sb0 Sb1
11. ADVANCED PROGRAMMING MENU
- Press
+
+
durante 5 segundos.
- Mediante las teclas
- Press
to validate and go to the next.
- The parameter sequence is as follows:
IT
TYPE
www.proindecsa.com / proindecsa@proindecsa.com
SYSTEM REACTION
Only if we have activated the rapid cycle
alarm (rc1&rc2) in the previous step, can
we select what period of time between 3
consecutive starts, in seconds, we consider
a rapid cycle between 1" and 99".
Allows you to activate the stand-by mode
of the display (Sb1) or deactivate it (Sb0) to
save energy.
o
se modificarán los valores.
SYSTEM REACTION
Allows you to select the type of operation as a con-
ventional pressure switch (nc = normally closed) or
reversed (no = normally open). *see note 3
Allows to select the working mode: Individual
mode(E00), or Master(E01) and Slave(E0) mode.
Allows to set the offset between Pstart 1 and Pstart
2 or between Pstop 1 and Pstop 2.
Allows to set a connection delay between 0 and 9
seconds.
Allows to set a time delay between 0 and 9 seconds
after disconnection.
Enables the ART automatic periodic reset system to
be activated (Ar1) or deactivated (Ar0).
Allows to set a minimum working pressure below
which the device would detect a lack of water.
+
+
19
BY DEFFECT
3 SECONDS
Sb1
(diagrama C)
BY DEFFECT
Publicidad
