Publicidad
Idiomas disponibles
Idiomas disponibles
10
English
7.3
Stopping operation (Pauses)
Slide the trigger (A5) backward if previously locked on, then release the trigger. If not switched off the appliance will automatically shutdown after one
hour of pause.
7.4
Finishing work
Slide the trigger (A5) backward if previously locked on, then release the trigger. Turn off the appliance (A4). Put the remaining solution in an external
container and store it according to the instructions given by the producers. Do not disperse the remaining solution after use. Rinse the appliance with
fresh water and dry it after use and before storage to greatly extend lifetime. Many spray liquids will dry out and harden if left in the tank, blocking the
nozzle, the valve and the hose.
8
MAINTENANCE
Warning - danger!
All installation and assembly operations must be performed with the appliance off.
Always switch off the appliance before any servicing or maintenance work. Repairs and work on electrical systems may only be carried out by the Service Centre.
Do not change the original structure of the product or the connection of the power cord. The O ring and washer are wear parts. The replacement frequency depends
on the service time, the spray materials used, and whether the sprayer is cleaned regularly.
Warning - danger!
Never use abrasive detergents, glass detergents or universal detergents! Never immerse the sprayer in water. Clean the appliance and plastic
accessories with a standard synthetic material detergent. Rinse the tank and accessories with water if necessary and dry them before reuse.
8.1.
Maintenance of the battery pack
Please pay attention to the charge of the battery pack. Charge in time in case of low battery. In the case of long-term power loss, the battery
performances will be lowered. After a long period of storage, the battery needs to be charged and discharged many times for maximum performance.
EN
EN
8.2
Charging and storage of the battery
To extend the service life of the battery, avoid charging immediately after a full discharge and cool the battery pack for a few minutes. In order to ensure
the constant temperature operation of the product and extend the working time and service life of the battery, avoid using it when the battery surface is hot.
8.3
Filters cleaning
Keep always filters clean. Clean inlet filter (Fig. 1, A12) after every use.
9
TRANSPORT AND STORAGE (PAGE 45)
Warning - danger!
All installation and assembly operations must be performed with the appliance off. Transport the appliance as shown in fig. 8. After finishing work, clean the
appliance; store them on the handle (A7, fig. 8). Take care to not to damage the appliance during transport. Store it on a flat and stable surface (fig. 9). Empty the
appliance in case of transport and storage. Store the appliance in a dry place and do not never leave it outdoor. Protect it from freezing.
10
TROUBLESHOOTING
Problem
The appliance does not switch on
The battery does not charge
The appliance stops while working
The pumps is under pressure but the
liquid does not come out
Possible causes
Battery empty
The battery has overheated and the internal auto reset
protection has cut in
Appliance or battery faulty
Charger not correctly connected to the device
Battery charger or battery not ready for charging. Battery
overheated.
Battery charger or battery faulty
Battery empty
The battery has overheated and the internal auto reset
protection has cut in
Filters or lance nozzle are clogged
Tank empty
Remedy
Fully charge the battery
Wait for the battery to cool down
Contact an authorised service centre
Take out the charger and insert it correctly
Wait for the battery to cool down
Replace the charger and/or contact an authorised service centre
Fully charge the battery
Wait for the battery to cool down
Check and clean the nozzle
Fill the tank
(Original instructions)
Publicidad
