Publicidad
Idiomas disponibles
Idiomas disponibles
(Original instructions)
4.3
Disposing of packaging
The packaging materials are not environmental pollutants but must still be recycled or disposed of in compliance with the relevant legislation in the
country of use.
5
TECHNICAL INFORMATION (PAGE 3)
5.1
Intended use
The appliance is intended for use as a sprayer for liquid solutions only, in compliance with the descriptions and safety precautions contained in these
instructions.
5.3
Main components:
A1 Nozzle
A2 Gun bar
A3 Cap
A4 Switch button with charge indicator LED
A5 Gun trigger
A6 Gun handle
5.4
Safety devices
Switch button (A4): the starter device prevents accidental use of the appliance.
6
INSTALLATION (PAGE 3)
Warning - danger!
All installation and assembly operations must be performed with the appliance off.
The assembly sequence is illustrated on page 3.
6.1
Assembly
Remove the parts of the sprayer from the box. Install the gun bar (A2) and the shoulder strap (A11, fig. 2).
6.2
Battery charging (fig. 3)
IMPORTANT! Before using the device it is necessary to fully charge the battery. Do not fully discharge the battery to keep it efficient.
Recharge only with the battery charger indicated by the manufacturer. An inappropriate battery charger can cause a fire hazard when used
with other battery units.
Check that the electricity supply voltage and frequency (V/Hz) correspond to those specified on the data plate. See fig.1.
Plug the battery pack charger (B1) to the power supply and connect the USB plug to the USB charging socket on the appliance (A8), opening the rubber
cover (fig. 3). During the charge, the appliance can't work and the charging indicator led (A4) is red. When fully charged, the charging indicator turns
green. Firmly close the rubber cover before starting the appliance. The battery has been charged before delivery. However, it will discharge automatically
during transportation and storage. It is recommended to recharge it before the first use. If the charging indicator stays off or doesn't turn green after
charge, contact the service Centre.
Recharge the battery after each use. In case of no-use, charge the battery every 3 months. If the performances decrease significantly,
recharge the battery. After a certain period of use, the battery must be replaced. The battery lifetime is influenced by several factors: charge/
discharge cycles, heavy-duty use, aging since manufacturing date, lack of charge and care, storage at high temperatures.
7
INFORMATION ON USE OF THE APPLIANCE (PAGE 4)
7.1
Preparation
Open the cap (A3) and fill the tank body (A10, fig. 4). Test the sprayer with fresh water before adding chemicals. Prepare the solution in an external
container. The cap (A3) can be used as a measuring cup. Do not fill the tank over the maximum quantity. Close the cap (A3) firmly. In case of a change
of liquid, clean the tank with fresh water. Do not disperse the rinsing solution. Keep the appliance at a comfortable height to put it on shoulder. Adjust
shoulder strap (A11) before use.
7.2
Start-up
Press the switch button (A4, fig. 5). Press the trigger (A5) to start the flow; push forward the trigger when pressed to keep it on (fig. 6). Adjust the nozzle
(A1) to switch from stream to mist spraying (fig. 7). Release the trigger to put the device in stand-by.
Warning - danger!
Hold the gun component firmly in both hands. Make sure the base is firm and safe. Operate the appliance upright. Do not cover the appliance
or use it in a poorly ventilated room.
IMPORTANT! Avoid operating the appliance without water, which may cause damage to the pump. Solutions must not have
temperature higher than 40°C.
A7 Handle
A8 Micro USB charging socket
A9 Outlet hose
A10 Tank body
A11 Shoulder strap
A12 Inlet filter
English
B1 USB battery charger
9
EN
EN
Publicidad
