Descargar Imprimir esta página

Annovi Reverberi AR Spray 8 Traduccion De Las Instrucciones página 8

Rociador de batería

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 25
8
English
3.6.15 Do not use the spray at below 0 °C or when frozen. The frost damage is not covered by the warranty!
3.6.16 Strictly follow the safety instructions for harmful chemicals.
3.6.17 Use exclusively products approved by local authorities and follow strictly the instruction given on the packaging
by the producers.
3.6.18 Do not disperse chemical solutions. Do not disperse water and solutions when rinsing and cleaning the machine.
3.6.19 After using the machine wash hands, face and clothes.
3.7
SAFETY WARNINGS OF THE BATTERY AND BATTERY CHARGER
3.7.1
Do not disassemble or tear the battery case. Do not hit it or drop it. Damaged batteries can cause serious danger.
3.7.2
Do not expose the battery to heat or fire. Do not expose it to direct sunlight. Do not leave it inside vehicles. Do
not expose it to temperatures over 45°C. Risk of explosion.
3.7.3
A battery used incorrectly can cause vapours to leak out. Ventilate the room and consult a doctor if necessary.
3.7.4
Keep batteries and electrical equipment out of the reach of children. It is good practice to keep children away from
electrical equipment.
3.7.5
Do not put any metal objects into the battery compartment. Do not put the battery away with other metal objects
(like the tool box) or with other batteries. Risk of generating a short circuit.
3.7.6
Use the battery charger in closed rooms sheltered from rain and humidity. Prevent possible electric shocks.
3.7.7
Always keep the battery charger clean. Dust and dirt prevent correct charging.
3.7.8
Before use, always check the battery charger, cable and plug. Do not use it in the event of damage or faults. Never
open the battery charger and only have it repaired by qualified staff and only with original spare parts.
3.7.9
Do not use the battery charger on easily flammable surfaces (e.g. paper, fabric, wood, etc.) or in flammable or
explosive environments. Prevent any fires due to overheating.
3.7.10 Charge the battery at room temperature between 10°C and 35°C. Lower or higher temperatures can damage the
battery and inhibit normal charging.
3.7.11 Unplug the battery charger when not in use. Do not leave the battery charger switched on with the battery
EN
EN
completely charged. Prevent possible accidents.
3.7.12 It is normal for the battery charger and the battery to heat up while being charged. However, both must be left to
cool down to room temperature between consecutive charging. High temperatures can cause damage or explosion of the
battery.
3.7.13 Replace batteries that have come to the end of their use cycle. If the battery loses its charge very quickly and/or the
charging cycles are very short, it means that it is nearly dead and therefore needs replacing.
3.7.14 Only replace it with original batteries, of the same type and characteristics as the one supplied with the tool. The
use of batteries of different types and voltages can damage the tool and cause danger. Only buy original spare parts.
3.7.15
The battery has auto reset thermal protection, which prevents charging should the temperature be too high. Disconnect
the battery from the charger for a few minutes before charging it again. Charging will start again automatically when the
temperature has returned within the safe range of values.
3.7.16 The power supply voltage of the battery charger must match that indicated on the technical data nameplate. Do
not use any other type of power supply.
3.7.17 It is advisable to install a trip switch on the electrical power supply line. Consult your electrician.
3.7.18 Do not damage or tread on the power supply cable. Do not pull the battery charger by the cable. Do not pull the
cable in order to unplug it from the power supply.
3.7.19 Any extension cable must have a higher section than that of the battery charger cable and correctly sizedaccording
to its length.
3.7.20 If the machine is blocked because the battery runs out, do not continue to press the switch button, otherwise the
battery fails hopelessly.
3.7.21 Do not fully discharge the battery. When the battery is almost discharged, recharge it immediately.
4
GENERAL INFORMATION (PAGE 3)
4.1
Use of the manual
This manual forms an integral part of the appliance and should be kept for future reference. Please read it carefully before installing/using the unit. If
the appliance is sold, the seller must pass on this manual to the new owner along with the appliance.
4.2
Delivery
The appliance is delivered partially assembled in a cardboard box.
The supply package is illustrated in fig.1.
4.2.1 Documentation supplied with the appliance
D1 Use and maintenance manual
D2 Safety instructions
D3 Declaration of conformity
D4 Warranty regulations
(Original instructions)

Publicidad

loading