Publicidad
Step 3
å
Push twenty SLATS (O) and two CENTER SLATS (P) into the
UPPER BACK RAIL (F).
å
NOTE: Be sure to position the SLATS exactly as shown.
å
Then, push the UPPER FRONT RAIL (D) onto the SLATS (O
and P).
å
Now, fasten the CENTER SLATS (P) to the UPPER RAILS (D
and F). Turn four 5/8" HEX HEAD SCREWS (6) through four
FLAT WASHERS (2), through the angled bracket on the SLATS
and into the UPPER RAILS a few turns using the L-WRENCH (3).
å
NOTE: Do not completely tighten the SCREWS at
this time.
2
6
(4 of each used)
F
O
O
430362
Edge with holes
O
O
O
O
O
O
O
www.sauder.com/service
O
O
O
O
P
P
O
D
5/8" HEX HEAD SCREW
(4 used in this step)
3
O
O
O
O
O
O
6
Edge with holes
Page 7
Publicidad
