Publicidad
Step 4
å
Push twenty SLATS (O) and two CENTER SLATS (P) into the
LOWER BACK RAIL (G).
å
NOTE: Be sure to position the SLATS exactly as shown.
å
Then, push the LOWER FRONT RAIL (E) onto the SLATS (O
and P).
å
Now, fasten the CENTER SLATS (P) to the LOWER RAILS (E
and G). Turn four 5/8" HEX HEAD SCREWS (6) through four
FLAT WASHERS (2), through the angled bracket on the SLATS
and into the UPPER RAILS a few turns using the L-WRENCH (3).
å
NOTE: Do not completely tighten the SCREWS at
this time.
2
6
(4 of each used)
G
Page 8
These holes should
be closer to this edge.
O
O
O
O
O
O
O
O
www.sauder.com/service
O
O
O
P
O
P
O
O
E
5/8" HEX HEAD SCREW
(4 used in this step)
3
O
O
O
O
O
O
6
430362
Publicidad
