DESCALING SIGNAL:
•
When warning light D blinks YELLOW and the machine beeps 3 times, a descaling cycle
should be carried out (see ch. Descaling).
HEATING:
•
Buttons A-B-C blink simultaneously.
WHEN THE WATER RUNS OUT DURING OPERATION:
•
When warning light D blinks RED and the machine beeps 3 times, the water tank is empty.
•
Fill the water tank with fresh, still water (Fig. 4).
•
Press one of the buttons A-B-C. Wait for the machine to complete the priming cycle and
fi ll with water.
•
When buttons A-B-C turn on and remain steadily lit, the machine is ready for use.
IF THE LEVER IS RAISED WHILE DISPENSING:
•
Raising the lever while dispensing a product (Fig. 1) may cause splashes of hot water.
Danger of scalding!
•
Warning light D blinks RED and the machine beeps. The appliance will immediately stop
dispensing.
•
Close the lever (Fig. 3).
•
Press one of the buttons A-B-C to reset the alarm.
•
The appliance is ready for use again.
To dispense "Espresso" or "Caffè crema", use solely buttons A or B (1st and 2nd from the top
respectively, lit in WHITE). The same buttons, depending on the quantity, are to be used for
dispensing capsules of orzo, ginseng, cocoa or milk.
Button C (3rd from the top, lit in BLUE) must be used solely for "Filter Coffee" or "Americano".
This same button can be used for capsules of tea, chamomile tea or herbal tea.
Do not use button C for espresso or any other coffee with an intense fl avour. In this function
the machine is set for low pressure and this reduces the "crema", diminishes the fl avour of the
coffee, and could cause a break in the fl ow.
NOTE: Traces of the product just dispensed may remain in the circuit of the machine.
To retain maximum beverage fl avour, when changing from one product to another,
rinse it briefl y.
Rinsing is carried out by dispensing a coffee without inserting a capsule.
20
English
General operating indications
Correct use of the buttons