Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
In case of extended working periods, the operating
personnel may suffer circulatory disturbances in their
hands (vibration white finger) due to vibrations.
Raynaud's syndrome is a vascular disease that caus-
es the small blood vessels on the fingers and toes to
cramp in spasms. The affected areas are no longer
supplied with sufficient blood and therefore appear
extremely pale. The frequent use of vibrating prod-
ucts can cause nerve damage in people whose circu-
lation is impaired (e.g. smokers, diabetics).
If you notice unusual adverse effects, stop working
immediately and seek medical advice.
ATTENTION
The product is part of the 20V gomag series and may
only be operated with batteries of this series. Batter-
ies may only be charged with battery chargers of this
series. Observe the manufacturer's instructions.
WARNING
Follow the safety instructions and the
notes regarding charging and correct use,
as specified in the operating manual for
your 20V gomag series battery and battery
charger. A detailed description of the
charging process and further information
are provided in this separate manual.
6
Technical data
Cordless angle grinder
Motor voltage
Speeds n
0
Dimension of cutting wheel
Thread dimension
Weight (without battery)
Subject to technical changes!
Noise and vibration
WARNING
Noise can have serious effects on your health. If the
machine noise exceeds 85 dB, please wear suitable
hearing protection for you and persons in the vicinity.
The noise and vibration values have been determined
in accordance with EN 62841-1.
26 | GB
Noise data
Sound pressure L
Measurement uncertainty K
Sound pressure L
Measurement uncertainty K
Vibration parameters
Surface grinding
Main handle Vibration a
Measurement uncertainty K
Additional handle Vibration a
Measurement uncertainty K
The total vibration emission values specified and the
device emissions values specified have been measured
in accordance with a standardised test procedure and
can be used for comparison of one electric tool with an-
other.
The total noise emission values specified and the total
vibration emission values specified can also be used for
an initial estimation of the load.
The noise emission values and vibration
emission value can vary from the specified
values during the actual use of the power
tool, depending on the type and the manner
in which the electric tool is used, and in
particular the type of workpiece being pro-
cessed.
Try to keep the stress as low as possible. For exam-
ple: Limit working time. In doing so, all parts of the
operating cycle must be taken into account (such as
GO-WS125BL
times in which the power tool is switched off or times
20 V
in which it is switched on, but is not running under a
load).
rpm
3000 - 10000
Ø 125 mm
M14
7
1.60 kg
Danger of injury!
Remove the battery from the power tool before carry-
ing out any work on the power tool (e.g. maintenance,
tool change, etc.) and when transporting and storing
it. There is a risk of injury if the on/off switch is oper-
ated unintentionally.
www.scheppach.com
pA
wA
h
h
WARNING
Before commissioning
WARNING
86.1 dB
3 dB
94.1 dB
3 dB
2
5.380 m/s
2
1.5 m/s
2
5.730 m/s
2
1.5 m/s
Publicidad
