Descargar Imprimir esta página

Snap-On CT9038 Traducción De Las Instrucciones Originales página 11

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 61
L1 L2 L3 L4
Figure
6: Fuel Gauge (CTB185/CTB1856)
L1 - Solid Light 25% Charge
L2 - Solid Light 50% Charge
L3 - Solid Light 75% Charge
L4 - Solid Light 100% Charge
A
B
C
Figure
7: Battery Pack (CTB8187)
A. Terminal
B. Latch Button
C. Fuel Gauge
L1
Figure
8: Fuel Gauge (CTB8187)
L1 - Solid Light 25% Charge
L2 - Solid Light 50% Charge
L3 - Solid Light 75% Charge
L4 - Solid Light 100% Charge
ZCT9038CE Rev. C
L2
L3
L4
Battery Pack
Fuel Gauge
Press the fuel gauge button, the display lights will light
up and show the battery pack's remaining capacity. The
lights stay on for 5 seconds.
Note: If fuel gauge L1 is flashing, charge the battery pack.
Charge Cycle Counter
Press the fuel gauge button for ten (10) seconds to read
the charge cycle counter.
Count number of flashes to figure out cycle count.
Example 1:
L1 - Flashes one (1) time
L2 - Flashes three (3) times
L3 - Flashes four (4) times
L4 - Flashes five (5) times
It means battery was charged 1, 345 times
Example 2:
L1 - No flashes
L2 - Flashes six (6) times
L3 - Flashes seven (7) times
L4 - Flashes eight (8) times
It means battery was charged 678 times
Battery Pack Protection
To maximize performance and battery life, the Lithium-
Ion battery's protection circuit monitors battery voltage,
discharge amperage and temperature. When the battery
voltage falls below the usable range, the battery will shut
off, and the 1st LED will flash for ten (10) seconds. The
battery needs charging. If the battery's discharge
amperage limit is reached, due to excessive load, the
protection circuit will shut down the tool. Tool operation
can be resumed immediately.
Cold Weather Operation
The Lithium-Ion battery can be used in temperatures
down to -4°F(-20°C). When the battery pack is very cold,
run the tool at no load to warm battery and then use the
tool normally.
Hot Weather Operation
If the Lithium-Ion battery temperature reaches
158°F(70° C), the protection circuit will turn off the
battery and all four LED's will flash for four (4) minutes.
Once the battery has cooled down below 149°F(65°C),
the battery will resume normal operation.
11
(10/23)

Publicidad

loading