Descargar Imprimir esta página

Snap-On CT9038 Traducción De Las Instrucciones Originales página 9

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 61
Application
Friction Ring Anvil
1. When installing an impact socket, place the forward/
reverse bar in the center position to avoid accidental
starting of the tool; or remove the battery pack.
2. Align the square of the socket with four flats at the
end of the anvil.
3. Push the socket over the friction ring, until it comes
to a stop.
4. To remove the impact socket, grip the socket firmly
and slip off the anvil.
This type of anvil is suitable for exchanging sockets regularly,
like in a garage environment.
Using the Speed Selector
The speed selector button is used to control the anvil
speed, impact speed, and torque output.
A
Figure
2: Speed Selector
The speed settings can be set independently for CCW
(reverse) and CW (forward). This feature can be used to
remove fasteners with full speed and reinstall them with
improved control at a lower speed.
1. Pull and release trigger to activate tool. The current
speed selection will be shown according to the speed
selector chart shown below.
2. Push the speed selector to cycle through the three (3)
speed modes. When the desired speed setting is lit,
begin work.
ZCT9038CE Rev. C
SPEED
SETTING
1
2
3
* Effect on torque % obtained using a 3/8" hex bolt.
Always use a torque wrench to verify torque.
LIGHT COLOR
Forward/Reverse Switch
The forward/reverse switch determines the rotating
direction
counterclockwise.
B
To change the direction of anvil rotation:
1. Be sure the impact wrench is stopped and not
operating.
2. The
determines the direction of the anvil rotation. Switch
positions, when tool is positioned as above, are:
— Forward (B), the anvil rotates clockwise,
— Reverse (A), the anvil rotates counterclockwise.
3. The switch must be in either the forward or the
reverse position to operate. Center position locks the
switch off.
9
SPEED
SELECTION
SPEED
DISPLAY
0-1000

0-1525

0-2050

Green
CCW (reverse)
Red
CW (forward)
of
the
anvil,
A
B
Figure
3: Forward/Reverse Switch
A. Depress switch for reverse or
counterclockwise rotation.
B. Release switch for forward or clockwise
rotation.
position
of
the
TORQUE
IPM
% *
0-2000
0-25%
0-2850
0-50%
0-3150
0-100%
DIRECTION
either
clockwise
or
forward/reverse
switch
(10/23)

Publicidad

loading