HT Instruments DM40 Manual De Instrucciones página 33

Fig. 5: Example of area measurement
4.7. Volume measurement
This measurement allows calculating the volume of
solids expressed in m
1. With the instrument in stand-by, press the
to select the desired type of reference (see § 4.2)
2. Press the
measuring section. The symbol "
the display with side "higher" flashing
3. Press
measurement (length) of the surface (see Fig. 6).
The corresponding value appears on the first partial
display. The symbol "
with side "1" flashing
4. Press the
measurement (width) of the surface (see Fig. 6).
The corresponding value appears on the second
partial display. The value of the corresponding area
is shown in the resulting display. The symbol "
appears
3
key twice to enter the Area/Volume
the
key again to perform the second
on the
2 3
, in or ft
key to
" appears on the display
EN - 12
" appears on
perform
display with side "2"
DM40
key
the first
"