Steinberg Systems SBS-MD-23 Manual De Instrucciones página 29

Idiomas disponibles

CAUTION!

Selecting the lower or middle value of the numerical range is

recommended. If the highest value is selected, there is a risk that the target will be

missed.

B. NOTCH mode (selective discrimination, indentation)

a) Press the MENU button, select NOTCH mode, then use the "+" or "-"

buttons to select the category of metal to be eliminated.

b) Each press of the "+" or "-" button moves to the next category. The cursor

over the selected metal type will flash. Press the NOTCH button to accept

the category selection. This will eliminate the selected target from the

search range. The detector will not find objects belonging to that

category.

If no button is pressed within 2 seconds, the device will go into standby

mode.

d) To restore an eliminated target to the detector's search list, enter NOTCH

mode again, use the "+" or "-" buttons to select the target to be restored

to the search list and then accept the selection with the NOTCH button.

CAUTION!

If the NOTCH function is applied to all categories, the detector will

not find anything.

CAUTION!

If after pressing NOTCH you want to select another setting, i.e. DISC

or SENS, wait about 3 seconds until the cursor above the target disappears (until the

unit exits NOTCH mode).

3. Adjust the sensitivity. Press the MENU button, select the SENS category, then

press the "+" or "-" button to increase or decrease the sensitivity. The

sensitivity level will be displayed on the LCD. The unit defaults to a sensitivity

level of 6/8. To find objects deep in the ground, the sensitivity must be higher.

If the sensitivity is set to the highest limit, it is possible that the detector will

emit false signals.

PLEASE NOTE: if the SENS, "+", "-" button is not pressed within 2 seconds, the

unit will go into standby mode.

4. Place the detector on a wooden or plastic table, and then the user should

remove any watches, rings, or metal jewelry the user is wearing.

5. Position the probe so that the flat part of the probe is facing the ceiling.

10030780