Steinberg Systems SBS-MD-23 Manual De Instrucciones página 33

1. Hold down the PP button to use the PINPOINT function.
2. Slowly move the probe over the selected location. If the detector finds a target,
it will beep and the signal indicator will show the signal strength. Release the
PP button.
3. Narrow down the search. Hold down the PP button again. Position the center
of the probe near where the detector found the target, but do not position the
probe directly over the target. Slowly move the probe over the selected
location. Now the sound will only be emitted when the coil is directly over the
target.
4. Repeat the procedure in step 3 several times. After each repetition of the
procedure, the detection field will become narrower and the detector will
indicate the position of the metal target more and more precisely.
5. The target is located where the sound is loudest and the signal strength is
greatest.
CAUTION! This method requires practice and good familiarity with the device.
3.4. Cleaning and maintenance
a) Turn off the unit before each cleaning.
b) Use only non-corrosive cleaning agents for cleaning the surfaces.
c) After each cleaning, all the parts should be dried well before the unit is used
again.
d) Store the unit in a dry and cool place protected from moisture and direct
sunlight.
e) Do not spray the unit with a stream of water or immerse it in water.
f) Make sure that no water enters through the ventilation openings in the casing.
g) Clean the ventilation openings with a brush and compressed air.
h) Perform regular inspections of the unit checking technical fitness and any
damages.
i) Use a soft cloth for cleaning.
j) Do not leave the batteries in the unit when it will not be used for a long time.
k) Do not clean the unit with acidic substances, medical products, diluent, fuel,
oil or other chemicals as this may cause damage to the unit.
INSTRUCTIONS FOR THE SAFE DISPOSAL OF BATTERIES.
Install 2 9V batteries in the unit.
Remove used batteries from the unit in the same way you put them in.
Return the batteries to a unit responsible for their disposal.
DISPOSAL OF USED UNITS.
At the end of its useful life, this product should not be disposed of with normal
household waste but should be taken to a collection point for the recycling of
electrical and electronic equipment. This is indicated by the symbol on the
product, operating instructions or packaging. The materials used in this unit are