Publicidad
PASO 22
MMU Nextruder: parts preparation
PASO 23
MMU Nextruder assembly (part 1)
Add the Idler assembly onto the extruder.
Fix it in place using the M3x25 Set screw.
In case you have the 4-screw version of the Nextruder, you might use the
M3x25 screw to temporarily hold the Idler assembly in place.
Add the Swivel assembly onto the extruder. The protruding part of the Idler nut FS
component should fit inside the filament sensor pocket in the heatsink, as seen in
the picture.
9A. MK4 Nextruder mod
Ensamblaje Original Prusa MMU3
Para los siguientes pasos, por
favor prepara:
Set screw M3x25 (1x)
If you own the 4-screw version
of the Nextruder, this specific
type of set screw is not
included.
Tension screws assembly (1x)
Swivel assembly (1x)
Idler assembly (1x)
Main plate assembly (1x)
PG-assembly (1x)
101
Publicidad
