Publicidad
PASO 1
Herramientas necesarias para este capitulo
PASO 2
Attaching the MMU unit (part 1)
The MMU3 unit should be placed in the middle of the top part of the printer's
aluminum frame.
Place the MMU3 unit onto the frame.
Attach it just by the top hooks.
Look from behind, there are "clamps", which will be used to lock the unit to the
frame in the next step.
182
10C. MK3.5 Setup and Calibration
Ensamblaje Original Prusa MMU3
Por favor prepara las herramientas
para este capítulo:
Unikey for tightening up the Festo
fittings.
1.5mm Allen key for Filament
sensor calibration
Llave Allen de 2.5mm para tornillos
M3
Phillips screwdriver for power cable
terminals
Publicidad
