ENAR STELLA Manual De Operación página 42

While operating
the machine
2.4 LAMP SAFETY
Description
en
Operating safety
8 STELLA
•
Keep the area behind the light tower clear of people and obstructions while raising
and lowering the tower.
•
Do not raise the tower or operate the machine in high winds. Considering the
safety factor,When the wind speed is less than 30kph, 5m height can be used.
When the wind speed is greater than 30kph and less than 50kph, 3m height can
be used. It is not recommended to use when the wind speed is greater than
50kph.Lower the tower immediately if high winds are expected in the area.
•
Do not raise, lower, or turn the tower while the unit is operating.
•
If any part of the tower hangs up, or the winch cable develops slack while raising
or lowering the tower, STOP immediately! Contact an authorized ENAR service
representative.
•
Lower the tower when not in use. The operator should prevent twisting and
pinching of cables and wires while lowering the tower mast
•
Make sure the generator or counterweight on the frame is within 50 - 85 kg range
before operating the machine.
The lamps provided with your Light Tower are Light-emitting diode(LED) lamp. The
luminaire contains constant-current driver(s) and LED module(s). It works under technical
conditions as the product labels indicate.
WARNING
Personal injury hazard.
•
Do not operate the Light Tower if a lamp is damaged.
•
Replace damaged lamps immediately.
•
Do not stare at the operating light source. The luminaire should be positioned so
that prolonged staring into the luminaire at a distance closer than 3.6 m is not
expected.
•
Replace damaged lamps according to the instructions in section Removing
/Replacing Lamps.
MULTIFUNCTION FLOODLIGHT TOWER