Ryobi RY24602 Manual Del Operador página 10

To install:
 Place the battery pack in the hedge trimmer. Align the
raised rib on the battery pack with groove in the hedge
trimmer's battery port.
WARNING:
Make sure the latches on each side of the battery pack
snap into place and the battery pack is fully seated and
secure in the hedge trimmer battery port before begin-
ning operation. Failure to securely seat the battery pack
could cause the battery pack to fall out, resulting in seri-
ous personal injury.
NOTICE:
When placing battery pack in the tool, be sure raised rib
on battery pack aligns with the bottom of the tool and
latches into place properly. Improper installation of the
battery pack can cause damage to internal components.
To remove:
 Depress the latches on each side of the battery pack to
release the battery pack from the hedge trimmer.
WARNING:
Battery tools are always in operating condition. Therefore,
switch should always be locked with hands free of the
lock-out button when not in use. Remove battery pack
when transporting or carrying hedge trimmer to avoid
accidental starting, which could result in serious injury.
STARTING AND STOPPING THE HEDGE
TRIMMER
See Figure 3.
To start:
 Remove the blade cover.
 Pull back and hold the lock-out button.
 Depress the switch trigger.
 Release the lock-out button. Continue to depress the
switch trigger for extended operation.
To stop:
 Release the switch trigger to stop the hedge trimmer.
 Upon release of the switch trigger, the lock-out button
will automatically reset to the locked position.
OPERATION
HOLDING THE HEDGE TRIMMER
See Figure 4.
The unit has both a front and rear handle. With the blade
directed away from you, hold the unit by both handles.
WARNING:
Always keep both hands on the hedge trimmer handles.
Never hold shrubs with one hand and operate the hedge
trimmer with the other. Improper operation of the hedge
trimmer could result in serious injury.
CUTTING TIPS
See Figures 5 - 6.
DANGER:
Never cut near electric cords or lines. If blade jams on
any electrical cord or line, DO NOT TOUCH THE BLADE!
IT CAN BECOME ELECTRICALLY LIVE AND VERY
DANGEROUS. Continue to hold the hedge trimmer by
the insulated rear handle or lay it down and away from
you in a safe manner. Disconnect the electrical service
to the damaged line or cord before attempting to free
the blade from the line or cord. Contact with the blade,
other conductive parts of the hedge trimmer, or live elec-
tric cords or lines will result in death by electrocution or
serious injury.
WARNING:
Clear the area to be cut before each use. Remove all
objects such as cords, lights, wire, or loose string which
can become entangled in the cutting blade and create a
risk of serious personal injury.
 Before starting the hedge trimmer, hold the unit with both
hands with the cutting blades directed away from you.
Always use the hedge trimmer properly.
 Do not force the hedge trimmer through heavy shrubbery.
This can cause the blades to bind and slow down. If the
blades slow down, reduce the pace.
 Do not try to cut stems or twigs that are larger than
3/4 in. thick, or those obviously too large to feed into the
cutting blade. Use a non-powered hand saw or pruning
saw to trim large stems.
 If blades do become jammed, stop the motor, allow the
blades to stop and remove the battery pack before at-
tempting to remove the obstruction.
8 — English