Publicidad
Idiomas disponibles
Idiomas disponibles
No.
Malfunction
The Station is not connected to the power supply�
The robot's Charging Contacts are not fully in contact with
the Station's�
The robot is unable to
6
charge�
The battery temperature is too high or too low�
The battery over-discharges due to prolonged periods of
non-use�
The Brush/Side Brush is entangled, or the Dust Bin/Filter
The robot is very loud
is blocked�
7
during cleaning�
The robot is in Strong Mode�
The robot is tangled with objects on the floor (electrical
The robot gets stuck
wires, curtains, carpet fringing, etc�)
8
while working and
The robot might be stuck under furniture with an entrance
stops�
of similar height�
Objects such as wires and slippers placed on the ground
During cleaning, the
may obstruct the robot�
robot may encounter
issues like a
disorderly route,
The Driving Wheels may slip on the ground when the robot
biased movement,
climbs steps, thresholds, and door bars, which can affect
repeated passes over
its ability to navigate the entire home environment�
the same spots, and
9
missing small areas�
On freshly waxed or polished floors, as well as smooth
(If a large area is
tiles, there may be less friction between the Driving
temporarily missed,
Wheels and the floor�
rest assured that the
robot will
Due to different home environments, some areas cannot
autonomously return
be cleaned�
to ensure thorough
cleaning�)
The Navigation Module may be dirty or blocked by foreign
objects�
Possible Cause
Solution
Make sure the Station is connected to the power supply and its indicator
light is on�
Make sure that the robot's Charging Contacts have full contact with the
Station's, and the button flashes� Check whether the robot's and Station's
Charging Contacts are dirty� Please clean these parts according to the
instructions in the [RUGULAR MAINTENANCE] section�
Please charge and use the robot within the temperature range of 0-40℃�
It is recommended that you use this product regularly� If charging issues
occur due to prolonged non-use, please contact customer service for
assistance�
It is recommended to clean the Brush, Side Brush, Dust Bin, Filter, etc�
regularly�
Switch to Standard Mode�
The robot will try various ways to free itself� If it is unsuccessful, manually
remove the obstacles and restart�
Please raise the furniture, set a physical barrier, or set a Virtual Boundary
via the YEEDI App�
Before cleaning, please tidy up scattered wires, slippers, and other objects
on the ground as much as possible� If there is any area missed during
cleaning, the robot will correct it automatically� Please refrain from
interfering (such as moving the robot or blocking its route)�
It is recommended to close the door of the affected area and cleaning
it separately� After cleaning, the robot will return to its starting location�
Please feel confident in using this method�
Please wait for the wax to dry before cleaning�
Tidy up the home environment to ensure that the robot can enter for
cleaning�
Wipe it with a clean, soft cloth or clear any foreign objects�
19 EN
Publicidad
