Publicidad
Idiomas disponibles
Idiomas disponibles
Device Update
Typically, some devices are updated bi-monthly,
but not always so specific�
Some devices, especially those that went on sale
more than three years ago, will only be updated if
a critical vulnerability is found and fixed�
To disable the Wi-Fi module on the robot, power the
robot ON� Place the robot on the Docking Station,
making sure the Charging Contacts on the robot
and the Docking Station Pins make a connection�
Then, double-tap the
To enable the Wi-Fi module on the robot, power
the robot OFF and then back ON� And unplug the
Station and plug it in again�
Federal Communications Commission (FCC) Interference
Statement
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules�
These limits are designed to provide reasonable protection
against harmful interference in a residential installation� This
equipment generate, uses and can radiate radio frequency
energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio
communications�
button�
However, there is no guarantee that interference will not occur
in a particular installation� If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the
following measures:
Reorient or relocate the receiving antenna�
Increase the separation between the equipment and receiver�
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected�
Consult the dealer or an experienced radio/TV technician for help�
This device complies with Part 15 of the FCC Rules / Industry
Canada licence-exempt RSS standard(s)� Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including
interference that may cause undesired operation�
Caution: Any changes or modifications not expressly approved
by the party responsible for compliance could void the user's
authority to operate this equipment�
MPE Requirements
To satisfy FCC / IC RF exposure requirements, a separation
distance of 20 cm or more should be maintained between the
antenna of this device and persons during device operation�
To ensure compliance, operations at closer than this distance is
not recommended�
7 EN
Publicidad
