Descargar Imprimir esta página

Nilfisk Advance SC370 17B Instrucciones De Uso página 25

Ocultar thumbs Ver también para Advance SC370 17B:

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTRUCTION FOR USE
WARNING!
WET battery charging produces highly explosive hydrogen gas. Charge the batteries in well-ventilated areas
and away from naked flames. Do not smoke while charging the batteries. Keep the tank open while charging
the batteries.
WARNING!
Pay careful attention when charging the batteries as there may be battery fluid leakages. The battery fluid is
corrosive. If it comes in contact with skin or eyes, rinse thoroughly with water and consult a physician.
Battery charging with battery charger installed on the machine
1.
Connect the battery charger cable (C, Figure13) to the electrical mains (A) the electrical mains voltage and frequency must be
compatible with the battery charger values shown on the machine serial number plate (41, Figure 2). When the battery charger is
connected to the electrical mains, all machine functions are automatically cut off. If the red warning light (E) on the battery charger
control panel stays on, the battery charger is charging the batteries.
2.
When the green warning light (D) turns on, the battery charging is completed.
3.
When the battery charging is completed, disconnect the battery charger cable (C) from the electrical mains (A) and wind it round
its housing (B).
E
NOTE
For further information about the operation of the battery charger, see the relevant Manual.
BRUSH/PAD CLEANING
CAUTION!
It is advisable to use protective gloves when cleaning the brush/pad because there may be sharp debris.
1.
Remove the brush/pad from the machine, as shown in the Use chapter.
2.
Clean and wash the brush/pad with water and detergent.
3.
Check that the brushes/pads are in working condition and not excessively worn; if necessary replace them.
A
B
C
D
Figure 13
21
ENGLISH

Publicidad

loading

Este manual también es adecuado para:

Advance sc37050000638