Publicidad
Idiomas disponibles
Idiomas disponibles
2. COMPONENTS AND TECHNICAL CHARACTERISTICS
All components of this equipment were designed and
manufactured using carefully selected materials to
their proper functions, according to test standards and
experience of Skymsen.
PICTURE 01
02
01
03
01 - Protection Lid
02 - Combs
03 - Combs Support
04- Rolls
CHARACTERISTICS
Voltage
Frequency
Motor Power
Height
Width
Depth
Net Weight
Shipping Weight
05 - On/Off Switch
06 - Housing
07 - Collect Box
TABLE 01
UNIT
AB
V
110
Hz
60
HP
0.5
mm
435
mm
225
mm
510
kg
22.6
kg
24.4
3. INSTALLATION AND PRE OPERATION
3.1 Positioning
The equipment must be placed on to a levelled stable
surface approximately 850 mm high.
Recommended area for equipment installation
05
550mm
06
Installation
04 04
07
3.2 Electrical Installation
The equipment has been designed to operate 110 Volts, 60
Hz. V you receive the equipment check the voltage indicated
on the cord label.
The power plug has 3 pins the middle pin is the ground. All
the 3 pins must be properly connected.
Make sure the network voltage is the same as indicated
on the cord label.
3.3 Pre Operation
Before to use the equipment all the parts to be in contact
with the product shall be washed with water and neutral
soap (see item 3.4 Cleaning).
Make sure the equipment is stable on the working surface.
The Combs (Pic.02) prevent the product to wound up on
the Rolls #.04 (Pic.01) and therefore help the product to be
expelled.
300mm
area
FRONT
850 mm
3
Publicidad
