Skymsen AB Manual De Instrucciones página 5

PICTURE 07
PICTURE 08
4.3.1 Placing the rollers
The rollers must be mounted on the support rollers as
described below:
- Place the rolls of support N ° 01 (Pic. 09) on a table.
- Single roll which has a flange and fit as Pic. 09.
- Each roll has its correct position in the roller support.
- Mount the roll with the flange in position as shown in
Pic. 09.
- It is not possible to mount the flange roll in the roller
position without the flange.
01
- Mount the second roll in its housing in the combs holder
as shown in Pic. 10.
- Note that the teeth on the face of each roller are facing the
respective sides.
Roll number 01
inclination direction
PICTURE 09
PICTURE 10
PICTURE 11
Roll number
inclination direction
FLANGE
02
5