Skymsen AB Manual De Instrucciones página 4

Always use the Combs (Picture 02) to process any
product.
4. OPERATION
4.1 Starting
To start the equipment:
- Plug the equipment on the power point.
- Press the ON/OFF Switch #.05(Pic.01) to position "I".
4.2 Operation Procedures
Under no circumstances use any instrument to feed
the meat inside the Protection Lid # 01 (Pic.01).
The meat tenderizers are machine working at LOW
ROTATION.
Simple to be used they however must call the operator total
attention to avoid what ever accidents might occur.
Place the meat inside the Protection Lid opening, and let it
fall freely inside the machine.
4.3 To assemble and to Remove the Rolls
Unplug the machine any time you have to take away
any of the removable part. Make sure the rolls # 04 (Pic
01) are totally still before to lift the Protection Lid # 01
(Pic.01).
PICTURE 03
4
PICTURE 02
PICTURE 04
Remove a comb at a time. Always do this operation
with protection cover mounted on the unit as illustrated in
Pictures 03 and 04.
-Remove The protective cover No. 01 (Pic. 01) pulling it back
and up as indicated by the arrow direction of Pic. 05.
01
-Place the protective cover No. 02 (Pic. 06) with the rollers
on a table.
- Lift the front Rollers of Support No. 01 (Pic. 06) until
the rolls of support lock disengage the existing plug-in
protection cover No. 02 (Pic. 06), and pull it forward until it
is totally out of the protective cap No. 02 (Pic. 06) as shown
in Pic. 06.
02 01
- Remove the rollers picking at their ends as indicated by
the arrows and pull them up as Fig 08.
- Remove the two rollers so that the support rollers is
completely empty, as shown in Fig 07 and Fig 08.
PICTURE 05
PICTURE 06
COMBS
SUPPORT
LOCKER
FITTING
COMBS
SUPPORT