Descargar Imprimir esta página

Vacmaster VFB511H 0201 Manual Del Usuario página 11

Aspiradora en mojado/seco

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING:
SURE THE PLUG IS DISCONNECTED BEFORE CHANGING THE FILTERS.
1. Verify that the power cord is disconnected from the outlet. Make sure that the collection tank is
clean and free of dust and dirt (Fig. 1).
2. Remove the cartridge filter, then carefully install the foam wet filter over the filter cage and place
the powerhead back on the collection tank. For foam wet filter installation instructions, see page
15 (Fig. 2).
DO NOT USE THE CARTRIDGE FILTER OR DUST COLLECTION BAG FOR LIQUID
VACUUMING.
OPERATING INSTRUCTIONS: WET VACUUMING
3. Push the required accessory onto the free end of the hose or extension wand (Fig. 3).
4. Verify that the switch is in the 'O' OFF position before plugging the power cord into the power
outlet. Plug the power cord into the outlet (Fig. 4 & 5).
5. Turn the vacuum on by flipping the switch to the 'I' ON position and begin vacuuming (Fig. 6).
6. Once you have completed vacuuming, flip the switch to the 'O' OFF position and unplug the
power cord from the outlet.
7. After use, empty the collection tank, clean and dry the inside and outside before storage (Fig. 7).
IMPORTANT! When vacuuming large quantities of liquids, do not immerse the nozzle completely
in the liquid; leave a gap at the tip of the nozzle opening to allow air inflow. The machine is fitted
with a float valve that stops the suction action when the collection tank reaches its maximum
capacity. You will notice an increase in motor speed. When this happens, turn off the machine,
disconnect from power supply, and drain the liquid into a suitable receptacle or drain. To continue
vacuuming, refit the powerhead to the collection tank. After wet vacuuming, turn the machine
off and remove plug from power supply. Empty the collection tank, clean, and dry the inside and
outside before storage.
REMEMBER! The foam wet filter must be removed after wet vacuuming and the cartridge filter
must be installed before dry vacuuming again.
DO NOT PLUG THE POWER CORD INTO THE POWER OUTLET. MAKE
11

Publicidad

loading