Publicidad
Idiomas disponibles
Idiomas disponibles
NOISE DIFFUSER
For quiet operation, install the noise diffuser into the blower port by inserting the locking end of the
diffuser into the blower port and turning clockwise to lock into place.
POLARIZED PLUG
To reduce the risk of electrical shock, this appliance has a polarized plug (one blade wider than the
other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet.
Do not change the plug in any way. Double insulation
grounded power cord and grounded power supply system.
DRY VACUUM OPERATION
1
2
7
8
DRY VACUUMING
WARNING:
ENTITLED "IMPORTANT SAFETY INSTRUCTIONS". DO NOT VACUUM IN AREAS
WITH FLAMMABLE GASES, VAPORS, OR EXPLOSIVE DUST IN THE AIR.
FLAMMABLE GASES OR VAPORS INCLUDE BUT ARE NOT LIMITED TO: LIGHTER
FLUID, SOLVENT TYPE CLEANERS, OIL-BASED PAINTS, GASOLINE, ALCOHOL,
OR AEROSOL SPRAYS. EXPLOSIVE DUST INCLUDE BUT ARE NOT LIMITED TO:
COAL, MAGNESIUM, GRAIN, OR GUN POWDER. TO REDUCE THE RISK OF HEALTH
HAZARDS FROM VAPORS OR DUST, DO NOT VACUUM TOXIC MATERIALS.
WARNING:
SURE THE PLUG IS DISCONNECTED BEFORE CHANGING THE FILTERS.
CAUTION:
WITH STANDARD WET/DRY FILTER. THIS IS A VERY FINE DUST WHICH WILL NOT
BE CAPTURED BY THE FILTER AND MAY CAUSE DAMAGE TO MOTOR. WHEN
VACUUMING FINE DUST USE A FINE DUST FILTER.
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. In order to prepare your vacuum for dry vacuuming, make sure the cartridge filter completely
covers the filter cage against the powerhead. Your wet/dry vacuum comes with the cartridge
filter pre-installed. For installation instructions, see page 14 (Fig. 2 & 3).
3
9
BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION
DO NOT PLUG THE POWER CORD INTO A POWER OUTLET. MAKE
DO NOT VACUUM DRYWALL DUST OR FIREPLACE SOOT OR ASH
eliminates the need for the three wire
4
5
10
9
6
Publicidad
