Corghi HD 700 Manual De Usuario página 56

15) Move the mobile control unit to work-
ing position B.
16) Move the hook tool so that its red reference
dot is positioned 3 cm. inside the rim.
17) Insert the bead lifting lever between the
rim and the bead to the right of the tool (see
Fig. 28).
18) Keeping the lever pressed down, lower the
wheel to bring the rim edge about 5 cm from
the hook tool, then turn the wheel anticlockwise
until the tyre comes completely off the rim.
CAUTION
When the beads come off the rim, the
tyre will fall.
Make sure that no one is accidentally
located in the work area.
MOUNTING
1) If the rim has been removed from the turn-
table, reclamp it as described in the "WHEEL
CLAMPING" paragraph.
2) Lubricate the tyre beads and rim using the
recommended soapy solution.
56
3) Tighten the rim gripper on the outer side
of the rim at the highest point (see fig. 29).
CAUTION
Make sure that the gripper is well at-
tached to the rim.
28
4) Move the mobile control unit to work-
ing position B.
5) Position the tyre on the platform and lower
the turntable (making sure to keep the gripper
in the highest point) to hook the first bead to
the gripper.
6) Lift the rim with the tyre hooked to it and
turn it anticlockwise about 15-20 cm. The tyre
will be positioned tilted across the rim.
7) Move the tool holder arm to the non-working
position; move it to the inner side of the tyre
and rehook it in this position.
8) Make sure that the hook tool is positioned
to the side of the wheel.
Otherwise, press the tool rotation lever and
turn it 180°.
9) Move the mobile control unit to work-
ing position D.
10) Move the tool forward so that its red refer-
ence dot is aligned with the external edge of
- E - Operator's manual HD 700
nglIsh
29