Corghi HD 700 Manual De Usuario página 58

the right of the valve (see Fig. 32).
26) Turn the turntable clockwise until the grip-
per is in the 9 o'clock position.
27) Move the tool holder arm to the working
position.
28) Move the tool forward until its red reference
dot is aligned with the external edge of the rim,
5 mm. away from it.
29) Turn the turntable slightly clockwise until
the bead guide lever (see fig. 33), available
upon request, can be inserted into its seat in the
hook tool.
58
30) Hold back the lever, which will guide the bead
into the rim well and continue rotation until the
tyre is completely mounted.
31) Remove the rim gripper.
Remove the tool by turning the turntable anti-
clockwise and moving it outward.
32) Tilt the tool holder arm to the non-working
position.
33) Position the platform under the wheel,
lower the turntable until the wheel rests on the
platform.
34) Move the mobile control unit to work-
ing position B.
35) With the tyre resting on the platform, check
32 that the valve is perfectly centres with its hole.
Otherwise, turn the turntable slightly to adjust
its position.
Fasten the valve with the ring nut and remove
the extension.
36) Completely close the turntable clamps, mak-
ing sure that the wheel is supported to prevent
it from falling.
CAUTION
This operation can be extremely danger-
ous!
Perform it manually if you are absolutely
certain you can maintain the wheel equi-
librium only.
For heavy, large sized wheels you MUST
use a suitable lifting device.
37) Move the platform in order to free the wheel
from the turntable.
38) Remove the wheel.
33
- E - Operator's manual HD 700
nglIsh