Flex SBE 64 18-EC Instrucciones De Funcionamiento Originales página 20

■ Begin removing the blade at the upper
portion and continue around the pulleys
(16). The blade may spring free during
removal. saw blades are sharp. Use care in
handling them.
■ The rubber surface of the pulleys (16)
should be inspected for looseness or
damage when changing the blade.
Adjust the workpiece guide (see
figure N)
WARNING!
Remove the battery pack before adjustment.
SBE 64 18-EC
■ Loosen the two guide adjustment screws
(9a) with the included hex key (14).
■ Move the workpiece guide (8) to the
desired position.
■ Securely tighten both screws (9a).
SBE 127 18-EC
■ To adjust the three position workpiece
guide, press the guide adjustment
button(9b) and slide the workpiece guide
(8) to the desired position detent.
LED light (see figure O)
The LED light (7) will automatically turn on
with a slight squeeze on the variable-speed
trigger switch before the tool starts running
and will turn off approximately 10 seconds
after the trigger switch is released.
The LED light will rapidly flash when the tool
and/ or battery pack becomes overloaded or
too hot, and the internal sensors will turn the
tool off. Rest the tool for a while or place the
tool and battery pack separately under air
flow to cool them.
The LED light will flash more slowly to
indicate that the battery is at low-battery
capacity. Recharge the battery pack.
Saw hook (see figure P)
WARNING!
When the saw is hung by the hook, do
not shake the saw or the object that it is
hanging from.
WARNING!
Make sure that the structure used to hang
the saw is secure. Personal injury or property
damage may occur.
20
SBE 64 18-EC/SBE 127 18-EC
WARNING!
Only use the hook for hanging the saw.
Using the hook to hang anything else could
lead
to serious injury.
To use, lift up the saw hook (10) until it snaps
into the open position.
When not in use, always lower the hook until
it snaps into the closed position.
Variable speed trigger switch(see
figure Q)
SBE 64 18-EC
To turn the tool "ON", press and hold the
lock-off button (1), then squeeze the trigger
switch(12). Release the lock-off button (1) and
continue to squeeze the trigger switch (12)
for continued operation.
To turn the tool "OFF", release the trigger
switch (12).
The variable-speed trigger switch (12)
delivers higher speed with increased trigger
pressure and lower speed with decreased
trigger pressure.
SBE 127 18-EC
To turn the tool "ON", depress the lock-off
button from the side marked with "
squeeze the trigger switch(12).
To turn the tool "OFF", release the trigger
switch (12).
To prevent the saw from being activated
unintentionally, depress the lock-off button
from the side marked with "
trigger switch will be locked.
The variable-speed trigger switch (12)
delivers higher speed with increased trigger
pressure and lower speed with decreased
trigger pressure.
Speed dial (see figure R)
The band saw has a speed dial (2) to set the
different speed.
Rotate the speed dial (2) to "6" for maximum
speed or to "1" for minimum speed (SBE 64
18-EC).
Rotate the speed dial (2) to "5" for maximum
speed or to "1" for minimum speed(SBE 127
18-EC).
", then
" and the