Lindy 38346 Manual De Usuario página 5

User Manual
Installation
Transmitter
1. POWER LED: Indicates Power.
2. LINK LED: This will illuminate when the connection between transmitter and receiver is active, will
flash when the units have connection problems or there is low power.
3. USB-C LED: This will illuminate when the USB-C IN port is selected as video signal input.
4. HDMI LED: This will illuminate when the HDMI IN port is selected as video signal input.
5. SELECT button: Press to switch between HDMI and USB-C inputs.
6. EDID DIP switch: EDID settings.
00- Copy display's EDID (default)
01- 4K30 4:4:4
10- 1080p60 4:4:4
11- 1200p60 4:4:4
7. USB 2.0: 3x USB Type A ports, connect to mouse, keyboard or other USB devices (max. power
500mA)
8. SERVICE: Reserved for firmware updates and API command control.
9. HDBaseT OUT: Connect a compatible HDBaseT receiver using a single Cat.6A or above cable for all
data signals. Please do not connect to a network port.
10. Data signal LED (yellow): This will illuminate when the video signal is with HDCP, will flash if the
video signal is without HDCP.
11. Link signal LED (green): This will illuminate when the connection between transmitter and receiver is
active, will flash when the units have connection problems or there is low power.
12. HDMI IN: Connect to an HDMI source device.
13. USB-C IN: Connect to a Type C source device; this port can support video signal if the source is with
DP ALT mode, can be used also for USB 2.0 signal transmission and can provide 60W charging
power only when the included power supply is connected to the TX unit.
14. USB HOST: Connect to a USB source device. This port follows HDMI IN port, when that input port is
selected, the USB 2.0 signal is delivered to RX only from this USB HOST port.
15. L/R OUT: 3.5mm Audio analog port for audio de-embedding output.
16. IR IN: Connect the supplied IR Receiver cable for IR signal reception. Ensure the remote being used
is within the direct line-of-sight of the IR Extender.
English