Lindy 38346 Manual De Usuario página 6

User Manual
17. IR OUT: Connect the supplied IR Transmitter Cable for IR signal transmission. Place the IR
Transmitter in direct line-of-sight of the equipment to be controlled.
18. RS-232: Connect to a PC, Serial Controller or Serial device via a phoenix block 3-way connection for
the pass-through transmission of RS-232 and API commands.
19. DC 24V: Connect the 24VDC 3.75A PSU to an AC wall outlet and securely connector to the
transmitter or receiver. This is only required at one side of the installation, please note that to provide
60W charging power to the USB-C IN port, it has to be connected to the transmitter.
20. POC switch: Turn ON/OFF the PoC function.
Receiver
1. POWER LED: Indicates Power.
2. LINK LED: This will illuminate when the connection between transmitter and receiver is active, will
flash when the units have connection problems or there is low power.
3. IR IN: Connect the supplied IR Receiver cable for IR signal reception. Ensure the remote being used
is within the direct line-of-sight of the IR Extender.
4. IR OUT: Connect the supplied IR Transmitter Cable for IR signal transmission. Place the IR Transmitter
in direct line-of-sight of the equipment to be controlled.
5. SERVICE: Reserved for firmware updates and API command control.
6. HDBaseT IN: Connect a compatible HDBaseT transmitter using a single Cat.6A or above cable for all
data signals. Please do not connect to a network port.
7. Data signal LED (yellow): This will illuminate when the video signal is with HDCP, will flash if the video
signal is without HDCP.
8. Link signal LED (green): This will illuminate when the connection between transmitter and receiver is
active, will flash when the units have connection problems or there is low power.
9. HDMI OUT: Connect to an HDMI display.
10. USB 2.0: 2x USB Type A ports, connect to mouse, keyboard or other USB devices.
11. L/R OUT: 3.5mm Audio analog port for audio de-embedding output.
12. RS-232: Connect to a PC, Serial Controller or Serial device via a phoenix block 3-way connection for
the pass-through transmission of RS-232 and API commands.
13. DC 24V: Connect the 24VDC 3.75A PSU to an AC wall outlet and securely connector to the transmitter
or receiver. This is only required at one side of the installation, please note that to provide 60W charging
power to the USB-C IN port, it has to be connected to the transmitter.
14. POC switch: Turn ON/OFF the PoC function.
English