Tabla De Contenido - Lindy 38346 Manual De Usuario

User Manual
API Commands
Connect the RS-232 port to a PC or control system with a 3-pin phoenix connector cable,
or connect the SERVICE port to a PC with a Micro USB cable.
Then, open a serial command tool to send ASCII commands to control the product.
RS-232 Communication Protocol
Baud rate: 115200
Data bit: 8
Stop bit: 1
Parity bit: none
The end mark of the command is "<CR><LF>".
Command Function
help Get the list of all the
commands
r fw version Get the firmware version
s reboot Reboot the device
s reset Reset to factory defaults
Example
help
r fw version
s reboot
s reset
Feedback
Help Info
FW Version:TX 1.00.02
RX 1.00.02
000. help
001. r fw version
002. s reboot
003. s reset
004. r status
005. s tx input x
006. r tx input
007. s tx autoswitch x
008. r tx autoswitch
009. s tx autoswitch mode x
010. r tx autoswitch mode
011. s rx downscale x
012. r rx downscale
013. s tx audio mute x
014. r tx audio mute
015. s rx audio mute x
016. r rx audio mute
017. s edid x to y
018. r edid x
019. r edid data x
020. s user edid x <y>
021. r user edid x
TX 1.0.0 RX 1.0.0
Reboot...
System Initializing...
Initialization Finished!
TX 1.0.0 RX 1.0.0
Sure to RESET to default
settings? Type "Yes" after
next prompt to confirm
English