Publicidad
Idiomas disponibles
Idiomas disponibles
• Use all parts of the blowing/suction pipe so that the
airflow can work close to the ground.
• Lightly moisten surfaces that are very dry or use a
spray to reduce the levels of dust.
• Do not work with a damaged, incomplete or modi-
fied product without the consent of the manufactur-
er. Before use, check the safety status of the prod-
uct, especially the mains connection cable and the
switch.
• Only use the product if it is fully assembled.
• Only use the product in leaf vacuum mode when the
collection bag is attached. Check the collection bag
regularly for wear or damage.
• Never operate the product with faulty guards or cov-
ers, or without guards.
• Note that the operator or user is responsible for ac-
cidents or hazards to other people or their property.
• Avoid wearing loose-fitting clothing or clothing with
hanging strings or ties.
• Operate the machine in a recommended position
and only on a firm, level surface.
• Do not use the machine on a paved surface or grav-
el surface where ejected material could cause inju-
ries.
• Always carry out a visual inspection before use to
check that the shredder, the bolts of the shredder
and other fasteners are secured, that the housing is
undamaged and that the guards and shields are in
place. Replace worn or damaged components in
sets to maintain balance. Replace damaged or illeg-
ible labelling.
Operation:
• Do not switch the product on if it is held the other
way round or not in the work position.
• Prevent unintentional starting. Make sure the prod-
uct is switched off before picking it up or carrying it.
Carrying the product with your finger on the switch
invites accidents.
• Do not aim the product at persons during operation,
in particular the air jet at eyes or ears.
• Ensure you have secure footing when working, par-
ticularly on slopes. Always hold the product firmly
with both hands and only work with a correctly ad-
justed carrying strap.
• Do not stretch your body too far and be careful not
to lose your balance.
• Keep your fingers and feet away from the suction
pipe opening and the impeller. There is a danger of
injury.
• Do not work with the product when you are tired or
are unfocused or after taking alcohol or tablets. Al-
ways take breaks from work in good time. Remain
sensible when working. Move slowly, do not run.
• Prolonged use of the product can lead to vibration-
induced circulatory disorders of the hands. Howev-
er, you can extend the duration of use by wearing
suitable gloves or taking regular breaks.
24 | GB
• Avoid operating the machine in bad weather condi-
tions, especially when there is a risk of lightning.
Only work in daylight or with good, artificial lighting.
• Do not vacuum any combustible, smouldering or
smoking materials (e.g. cigarettes, embers, etc.),
vapours or easily ignitable, toxic or explosive sub-
stances.
• Stop the machine and remove the battery from the
product. Ensure that all moving parts have come to
a complete stop:
– when the product is not in use, is being trans-
ported or is unattended;
– before clearing a blockage or blocked ducts,
– before checking, cleaning or other work on the
machine.
– after contact with foreign objects or in the event
of abnormal vibrations.
• Do not use the product in enclosed or poorly venti-
lated rooms.
• Do not use the product in the vicinity of combustible
fluids or gases. There is a risk of fire or explosion if
disregarded.
• In the event of an accident or a fault during opera-
tion, the product must be switched off immediately
and the batteries removed from the product. To rec-
tify faults, read chapter Troubleshooting or contact
our service department.
• Walk at walking pace, do not run.
• Before starting the machine, make sure that the
feeder is empty.
• Keep your face and body away from the feed open-
ing.
• Do not allow hands, other body parts or clothing to
be in the feeder, ejection port or near moving parts.
• Be careful to be stable when standing and not to
lose your balance. Avoid abnormal postures. When
feeding material, never stand on a higher level than
the level of the base of the machine.
• Do not stay in the ejection area when operating the
machine.
• Be very careful when feeding material into the ma-
chine. Do not vacuum any metal pieces, stones,
bottles, cans or other foreign objects.
• Do not allow processed material to accumulate in
the ejection zone as this may prevent proper ejec-
tion and cause reintroduction of the material via the
feed opening.
• Switch off the power source and disconnect the ma-
chine from the mains or remove the batteries if the
machine becomes clogged before cleaning it of de-
bris.
• Never operate the machine with defective guards or
shields or without safety devices, for example the
attached collection bag.
• Keep the energy source clean of debris and other
accumulations to prevent damage to it or possible
fire.
www.scheppach.com
Publicidad
