Publicidad
Idiomas disponibles
Idiomas disponibles
• When ordering please provide our article number as
well as type and year of manufacture for the prod-
uct.
8
Assembly
WARNING
Danger of injury!
Remove the battery from the power tool before carry-
ing out any work on the power tool (e.g. maintenance,
tool change, etc.) and when transporting and storing
it. There is a risk of injury if the on/off switch is oper-
ated unintentionally.
WARNING
Danger of personal injury!
Never use the cordless leaf vacuum/blower with only
one assembled suction tube part. After the three-
piece suction tube has been put together, it must not
be dismantled again into individual parts.
8.1
Fitting the middle blast/suction
tube (17) (Fig. 3)
Note:
There is a safety contact in the motor housing. If this is
not activated during assembly, the product may not
start. Ensure correct assembly.
1. Insert the middle blast/suction tube (17) into the mo-
tor housing (18).
2. Secure the middle blast/suction tube (17) at the top
with the screw (17a).
3. Secure the centre blast/suction tube (17) on the
side with a screw (16a). Use a Phillips screwdriver*.
* = not included in the scope of delivery!
8.2
Fitting the front blast/suction
tube (16) (Fig. 4)
1. Place the front blast/suction tube (16) on the middle
blast/suction tube (17).
2. Secure the front blast/suction tube (16) with a screw
(16a). Use a Phillips screwdriver*.
* = not included in the scope of delivery!
8.3
Assembling/removing the
collection bag (12) (Fig. 5)
1. Place the collection bag inlet with locking device
(11) on the ejection opening (19). Make sure that it
engages properly.
2. Hook the rear collection bag eye (7) into the hook at
the rear (6).
3. Hook the front collection bag eye (13) into the front
hook (14).
4. Remove the collection bag (12) in reverse order.
8.4
Fitting the carrying strap (20)
(Fig. 1, 2)
Note:
Never wear the carrying strap diagonally across your
shoulder and chest, but only on one shoulder, this al-
lows you to quickly remove the product from your body
in the event of danger. Open the buckle to be able to
open the catch quickly in the event of an accident.
1. Open the carabiner hook (20a) of the carrying strap
(20).
2. Clip the carabiner hook (20a) into the fastening eye
of the carrying strap (2).
3. Adjust the length of the carrying strap (20) to suit.
9
Before commissioning
ATTENTION
Always make sure the product is fully assembled
before commissioning!
9.1
Select operating mode (Fig. 6)
ATTENTION
The operating mode may only be changed at a stand-
still.
The operating mode can be selected using the mode
selector lever (10).
10 Operation
ATTENTION
Make sure that the ambient temperature does not ex-
ceed 50°C and does not fall below -20°C during work.
ATTENTION
The product is part of the 20V gomag series and may
only be operated with batteries of this series. Batter-
ies may only be charged with battery chargers of this
series. Observe the manufacturer's instructions.
www.scheppach.com
Use as a leaf vacuum.
Use as a leaf blower.
GB | 27
Publicidad
