Publicidad
Idiomas disponibles
Idiomas disponibles
CONNECTING THE EXTENSION
POLE BETWEEN THE POWER
HEAD AND THE POLE SAW
ATTACHMENT (Fig. 5)
WARNING:
any attachment while the power head is
running or with the battery pack installed.
Failure to stop the motor and remove the
battery pack may cause serious personal
injury.
This extension pole is designed to only be used with EGO PS1000/PS1000-FC/
PSX2510/PSX2510-FC. Never use it with other EGO attachments.
The extension pole increases the machine length by 3.3 ft (1 m), extending the cutting
range. It should be connected between the pole saw attachment and the power head. A
maximum of two extension poles can be used on one machine.
Follow the process in the section "CONNECTING THE POLE SAW ATTACHMENT TO
THE POWER HEAD" to install the extension pole between the pole saw attachment and
power head.
NOTICE:
Once assembled correctly, the pole saw attachment, extension pole, and the
power head should not separate when pulled. Always test the connection by pulling
them. Repeat the steps above if the pieces can be separated during test.
DANGER:
instructed above could result in serious injury or death.
To remove the extension pole, follow the instructions in chapter "To remove the pole
saw attachment from the power head" in the section "CONNECTING THE POLE SAW
ATTACHMENT TO THE POWER HEAD".
56-VOLT LITHIUM-ION COMMERICAL POLE SAW — PSX2510/PSX2510-FC
Never attach or adjust
Failure to secure the attachment and power head/extension pole as
Coupler on the
5
Extension Pole
Extension Pole
Coupler on the
Power Head
21
Publicidad
