Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:
or in contact with any surface.
To stop the pole saw
Move the pole saw away from cutting area, and then release the trigger switch to stop
the pole saw.
WARNING:
work breaks and after finishing work.
CUT LINE INDICATOR (Fig. 12)
The cut line indicator is located at the
front of the pole saw attachment, in line
with the saw chain. The cut line indicator
is designed to help the user understand
exactly where the bar and chain are
located relative to the branch/limb being
cut.
WORKING WITH THE MACHINE
(Fig. 13)
Preparation for cutting
1. Remove the battery pack.
2. Make sure that the chain is properly
mounted and correctly tensioned.
3. Check the side cover to ensure that it
is against the guide bar and saw chain
without any looseness and damage.
4. Check the oil level and fill the tank as needed. Make sure the chain is well
lubricated.
5. Check the sharpness of the cutting teeth of the saw chain.
6. Hold the pole saw with both hands: with the right hand on the rear handle and the
left hand on the front-assist handle (Fig. 13a).
28
56-VOLT LITHIUM-ION COMMERICAL POLE SAW — PSX2510/PSX2510-FC
Do not attempt to start the saw when the saw chain is in a cut
Always remove the battery pack from the power head during
12
Cut Line Indicator
13a
Publicidad
