Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
PROBLEM
Motor does not
run
Motor runs, but
chain does not
rotate.
The telescopic
pole cannot
be locked
securely after
pressing down
the quick
release lever.
56-VOLT LITHIUM-ION COMMERICAL POLE SAW — PSX2510/PSX2510-FC
CAUSE
◾
The battery pack is not
attached to the pole saw.
◾
No electrical contact between
the saw and battery pack.
◾
The battery pack charge is
depleted.
◾
The lock-off button is not
depressed before pressing
the trigger switch.
◾
The battery pack or power
head is too hot.
◾
Saw chain is bound in the
wood.
◾
Debris in bar groove.
◾
Debris in side cover.
◾
Chain does not engage drive
sprocket.
◾
The bolt and nut on
the quick release lever
became loose.
SOLUTION
◾
Attach the battery pack to the pole
saw.
◾
Remove battery pack, check contacts
and reinstall the battery pack.
◾
Charge the battery pack.
◾
Press and hold the lock-off button,
then depress the trigger switch to
turn on the pole saw.
◾
Allow the battery pack or power
head to cool until the temperature
drops to the recommended operating
temperature range.
◾
Release the trigger switch; remove
the saw chain and guide bar from the
wood, then restart the pole saw.
◾
Press the saw chain against the
wood, move the pole saw back and
forth to discharge the debris.
◾
Remove battery pack, then remove
side cover and clean out debris.
◾
Remove the battery pack and reinstall
the chain, making sure that the drive
links on the chain are fully seated on
the sprocket.
◾
Securely tighten the bolt and
nut by using two 10 mm socket
wrenches or adjustable wrenches
(not provided).
39
Publicidad
