Publicidad
Idiomas disponibles
Idiomas disponibles
With a cardboard casing (on request) (Rif. 6).
With cage in wood (on request) (Rif. 7).
When receiving the cabinet:
Make sure the packing is intact and that it does not display readily apparent
damages;
Carefully perform the unpacking operation in order not to damage the cabinet;
Check the integrity of the cabinet components;
In case you detect damages, immediately call the supplier;
Slowly remove the protective films without tearing them, to avoid glue residues; the
residues can be removed with appropriate solvents.
Proceed with a first cleaning using neutral products and dry with a soft cloth; do not
use abrasive substances or metallic sponges;
To correctly dispose of the packing, bear in mind that it is made up of: Wood -
Polystyrene - Polythene - PVC - Cardboard.
DO NOT use alcohol to clean the parts in methacrylate (Plexiglas).
During the unpacking operations, do not leave elements of the packing
unattended such as nails, wood, gripper rods, nylon, etc. and tools used for
the operation such as pliers, scissors, pincers, in the work area, which could
cause wounds and injuries.
These objects must be removed with appropriate means and brought to their
respective collection places.
11.Installation and environmental conditions - specialized technician -
Any modification to the installation described herein must be authorized by
ARNEG Spa
To ensure that the technicians appointed to installation may operate safely, we
recommend to use the instruments and protection clothing required by the safety
norms or by the laws in force in the country of installation. At any rate, always use
adequate equipment and clothing, such as: anti-injury boots, protection gloves,
spirit level.
For the installation, adhere to the following:
carefully examine the installation area, eliminating any danger to the operator;
Do not position the cabinet:
in environments where explosive gaseous substances are present;
in open air and therefore subjected to atmospheric agents;
near heat sources (direct sunlight, heating systems, incandescence lamps, etc.)
near air currents (near doors, windows, air-conditioning systems, etc.) that exceed
a speed of 0.2 m/sec.
Remove the supports in wood at the base (used for transport) and assemble the
adjustable feet (Rif. 9) positioning them so as to place the cabinet horizontally, aiding
yourself of a level (Rif. 10) to check proper alignment .
Before connecting the cabinet to the electrical line, make sure that the rating plate data
matches the characteristics of the electrical system to which the cabinet must be
attached.
For the cabinet to operate correctly, the room temperature and relative humidity must
not exceed the limits relative to climatic class 3 (+25°C; R.U. 60%) established by the
norms EN-ISO 23953 - 2 with which the counter has been tested
If the cabinet is displaced, re-check its levelling; an incorrect levelling
compromises operation of the cabinet.
12.Combining cabinets (Rif. 19) - specialized technician -
To combine two or more cabinets in channel, proceed as follows:
Disassemble the shoulders (if present).
Apply silicone along the entire perimeter of the two cabinets.
Position the cabinets side by side
Join the risers and the brackets, using the screws supplied
05060111 00 12/04/2010
Viersen
English
.
25
Publicidad
