FILL UP AND START-UP INSTRUCTIONS
The following procedures should be followed
on initial startup and whenever the spa is
drained for routine maintenance.
FILLING THE SPA WITH
WATER
1. Clear all the debris from your spa.
2. Be sure to open all jets to allow as much
air as possible to escape from the plumb-
ing during the filling process.
3. Use a garden hose to fill your spa with
water.
NOTE: Do not use hot or softened water.
4. As the water level rises, check inside the
equipment compartment for water leaks. It
may be necessary to tighten unions and/
or fittings that may have loosened during
delivery. There is no need to call for
service; this can easily be done by you. If
assistance is required, contact a customer
service representative at (888) 961-7727
Ext. 8440.
UNIONS
5. Under normal circumstances keep the
water level half way between the top of
the spa and grey filter ring or just above
the highest jets (whichever is higher).
Keep in mind that every person who
enters the spa will create a certain amount
of water displacement, depending on their
size and weight; as a result you may
need to reduce the amount of water you
normally have in the spa. To prevent the
water from hitting your topside control
or flowing over the top edge of the spa.
Additionally, failure to keep enough water
in your spa may result in damage to your
system & invalidate your warranty. If your
spa filter is sucking in air causing the
pump to cavitate, you need to add water!
6. Check the filter installation and make sure
the filter is not loose.
APPLYING POWER
1. Plug the spa into the 15 amp dedicated,
grounded wall outlet, or turn on power
from Main Panel and 230V Sub Panel.
2. Press the Jets button on the topside
control panel to activate the spa. Rotate
all the air control valves counterclockwise
and observe the increased jet action.
3. While the pump is running, leaks may
have occurred during transit. Check again
for water leaks at the drain cap, unions, or
fittings in the equipment compartment. If
water is leaking from one of these areas,
there is no need to call for service. Simply
tighten the fitting. If assistance is required,
call a customer service representative at
(888) 961-7727 Ext. 8440.
4. After checking your spa for leaks it is now
time to adjust your spa settings. Press
the "Up" or "Down" button on your topside
control panel until the display indicates
your desired temperature is set.
16