Baker Hughes Druck ADTS542F Manual De Instrucciones página 102

Capítulo 6. Localización de averías y pruebas
Número de error Descripción
4 Bootloader task registration has failed
5 Failed to warm up
6 Ps sensor failed or disconnected
7 Autoleak recovery activated
8 Bias Channel Pressure Ps Failed
9 Bias Channel Pressure Pt Failed
10 Bias Channel Vacuum Ps Failed
11 Bias Channel Vacuum Pt Failed
12 Invalid Current State
13 Pressure Ps valve curve has failed characterisation
14 Pressure Pt valve curve has failed characterisation
15 Vacuum Ps valve curve has failed characterisation
16 Vacuum Pt valve curve has failed characterisation
17 Invalid Curve Index
18 Invalid Curve Parameters
19 Zero Curve Volume
20 Flow decreased on entry
21 Flow at 40V smaller than linear end
22 Theoretical max flow < 40V flow
23 Curve fit error too large
24 Demand NULL
25 EXP out of range
26 LOG out of range
27 Measured NULL
28 Controller Pool
29 Control Memory
30 Invalid Next State
31 Test set must be at ground
32 Pressure Leak in Ps. Leak rate =
33 Pressure Leak in Pt. Leak rate =
34 Invalid Ps Demand
35 Ps pressure not settling
36 Ps Aim Overshoot
37 Ps aim value unobtainable
38 Invalid Ps Volume
39 Pt pressure not settling
Copyright 2014 Baker Hughes Company.
90 | Manual de instrucciones del ADTS542F/552F/553F/554F–Español
Tabla 6-1: Códigos de error (Continuación)