Baker Hughes Druck ADTS542F Manual De Instrucciones página 110

Capítulo 6. Localización de averías y pruebas
Número de error Descripción
292 Qc sensor failed
293 Limit entry changed to Max limit set
294 Limits in controller flash are invalid
295 CAS is outside MAX limits
296 Alt is outside MAX limits
297 ROC is outside MAX limits
298 Qc is outside MAX limits
299 Ps is outside MAX limits
300 RtPs is outside MAX limits
301 Qc zero valve disconnected
302 Qc zero valve driver fault
303 Ground valve disconnected
304 Ground valve driver fault
305 Pt output valve disconnected
306 Pt output valve driver fault
307 Ps output valve disconnected
308 Ps output valve driver fault
309 Hand terminal short circuit
310 Reserved
311 Cannot connect Hand Term while safe at ground for this version of ADTS505
312 RtCAS is fixed and cannot be altered
313 Calibration date not entered. Enter the calibration date
314 No Handset code in LDK flash
315 Invalid Pt/Pt rate aim entry whilst in aero units
316 Invalid Qc/Qc rate aim entry whilst in Pt ramp mode
317 Invalid Pt/Pt rate aim entry whilst in Qc ramp mode
318 Entry capped to ground pressure specification limit
319 Controller board in position 1 programmed as controller 2
320 Controller board in position 2 programmed as controller 1
321 Board temperature error
322 Source sensor pressure initialisation error
323 Source sensor vacuum initialisation error
324 Board temperature read error
325 Source sensor pressure read error
326 Source sensor vacuum read error
327 ADC synchronisation initialisation error
Copyright 2014 Baker Hughes Company.
98 | Manual de instrucciones del ADTS542F/552F/553F/554F–Español
Tabla 6-1: Códigos de error (Continuación)