Baker Hughes Druck ADTS542F Manual De Instrucciones página 108

Capítulo 6. Localización de averías y pruebas
Número de error Descripción
220 Cannot Modify Altitude Correction in Pressure Units
221 Changed Aim to ARINC Limit
222 Calibration data failed
223 Cannot enter EPR in Aero Units
224 Invalid stored end user
225 Invalid end user
226 Invalid end user switch
227 Changed Aim to Current Limit
228 Limits Overlap
229 Limits Saved
230 Fan 1 Failed
231 Fan 2 Failed
232 LDK Task Failed
233 Read only Limits
234 Hourscreen timer failed
235 Workstation event has failed to initialise
236 Workstation memory pool has failed
237 Workstation serial HISR failed to initialise
238 Workstation task has failed to initialise
239 SPI Parameter Error
240 Test Message
241 Ground Request in Leak Mode. Select Control Mode then retry
242 LDK has an invalid data flash archive
243 LDK has an invalid EEPROM archive
244 Controller has an invalid data flash archive
245 Controller has an invalid EEPROM archive
246 Hand terminal has an invalid data flash archive
247 Hand terminal has an invalid EEPROM archive
248 LDK EEPROM Database has been rebuilt
249 Controller EEPROM Database has been rebuilt
250 Vacuum pump processor has failed
251 Vacuum pump lead is disconnected
252 Vacuum pump transistor is faulty or drive inhibited
253 Vacuum pump has stalled
254 Pressure pump processor has failed
255 Pressure pump lead is disconnected
Copyright 2014 Baker Hughes Company.
96 | Manual de instrucciones del ADTS542F/552F/553F/554F–Español
Tabla 6-1: Códigos de error (Continuación)