HomeMatic HmIP-DLD Manual De Instalacion Y Uso página 24

Start-up
6.2 Pairing
Please read this entire section
before starting the pairing proce-
dure.
First set up your Homematic IP
Access Point via the
Homematic IP app to enable ope-
ration of other Homematic IP
devices within your system. For
further information, please refer
to the operating manual of the
Access Point.
You can connect the device either
to the Homematic IP Access Point
or the Central Control Unit CCU3.
For detailed information, refer to
the WebUI manual on our home-
page at www.homematic-ip.com.
To integrate the device into your sys-
tem and to enable control via the
Homematic IP app, you must pair the
device to your Homematic IP Access
Point first.
To pair the temperature and humiditiy
sensor, please proceed as follows:
• Open the Homematic IP app on
your smartphone.
• Select the menu item "Pair device".
• Remove the battery compartment
cover (E) on the right side of the
device by pulling the cover off
using the notches at the bottom of
the device.
• Remove the insulation strip from
the battery compartment of the
device.
• pairing mode remains activated for
3 minutes.
You can manually start the pair
mode for another 3 minutes by
pressing the system button (C)
shortly.
24