Replacing batteries
9 Replacing batteries
If the symbol for empty batteries ( )
appears in the app, replace the used
batteries by three new 1.5 V LR6/ mig-
non/AA batteries or NiMH batteries of
type 1.2 V HR6/mignon/AA. You must
observe the correct battery polarity.
To replace the batteries of the device,
please proceed as follows:
• Remove the battery compartment
cover (E) on the right side of the
door lock drive
by pulling the cover off using the
notches at the bottom of the de-
vice.
• Remove the used batteries.
• Insert three new 1.5 V LR6/ mig-
non/AA batteries or NiMH batteries
of type 1.2 V HR6/mignon/AA into
the compartment, making sure
they are the right way around. The
device LED (C) LED shortly flashes
orange and the green. In additi-
on, the device emits a short audio
signal.
• Reattach the battery compartment
cover and latch it into place.
• Pay attention to the flashing signals
of the LED (C) after inserting the
batteries
(see „10.4 Error codes and
flashing sequences" on page
(siehe
Abbildung),
31).
Once the batteries have been inserted,
the device will perform a self-test (ap-
prox. 2 seconds). Afterwards, initialisa-
tion is carried out. The test display will
indicate that initialisation is complete:
orange and green lighting. Open the
door by pressing and holding the un-
lock button (B) to detect the lock sta-
tus.
Remove or change used batteries
immediately to prevent the batte-
ries from leaking.
Always replace all batteries in the
device and use batteries of the
same type/from the same manu-
facturer only.
If the battery voltage is getting
low it is displayed via the app.
Furthermore, the device emits an
audio signal and the device LED
(C) flashes orange after every
basic function actuated. Change
the batteries in this case. The set-
tings will not be lost.
Contact with batteries that are
dead or damaged can cause skin
irritation. Use protective gloves in
this case.
If not used for any length of time
(e.g. when in storage), remove the
batteries to avoid damages caused
by leaking, etc.
29