HomeMatic HmIP-DLD Manual De Instalacion Y Uso página 28

Operation
Automatic mode
The door is locked automatically du-
ring a previously set period of time.
The time period can be individually de-
fined via the week program of the door
lock drive.
Further information on configu-
ring and controlling the door lock
drive via the Homematic IP app
can be found in the Homematic IP
user guide at
www.homematic-ip.com.
8.2 Device operation
Unlock
The lock bolt moves to the unlocked
position. Upon completion of the pro-
cedure, an audio signal is emitted on
the lock actuator. To unlock the door
manually with the device, please pro-
ceed as follows:
• Press the button "Unlock" (B) at the
door lock one time briefly.
After replacing the batteries or
changing the device settings,
open the door once by pressing
and holding the "Unlock" button
(B) so that the lock status is cor-
rectly reported again.
Open
The lock bolt is retracted so that the
door is opened. Upon completion of
the procedure, an audio signal is emit-
ted on the lock actuator.
To open the door manually via the de-
vice, proceed as follows:
• Press the button "Unlock" (B) at the
door lock drive once long.
Lock
The lock bolt moves to the locking po-
sition. Upon completion of the proce-
dure, an audio signal is emitted on the
device. To lock the door manually with
the device, please proceed as follows:
• Press the button "Lock" (D) on the
door lock drive one time briefly.
8.3 Emergency operation
The lock can be unlocked/locked ma-
nually in the following two ways:
From inside with the rotary wheel:
In standby mode, the door lock drive
is disengaged, i.e. the gearbox is free-
wheeling. By turning of the rotary
wheel (A) the door lock drive can be
unlocked or locked and the door can
also be opened. The door lock drive
must be in idle status (motor not mo-
ving).
From outside with a key:
The lock can be locked, unlocked or
opened also from outside, if a lock
cylinder with emergency and hazard
function is used. The door lock drive
must be in idle status (motor not mo-
ving) in this case.
Do not tighten the screws that
fasten the door lock drive to the
mounting plate too tight, since it
might jam the drive and make
opening from outside difficult.
28