HomeMatic HmIP-DLD Manual De Instalacion Y Uso página 25

Mounting
Your device will automatically appear
in the Homematic IP App.
• To confirm, enter the last four di-
gits of the device number (SGTIN)
in your app or scan the QR code.
See the sticker supplied or at-
tached to the battery compartment
of the device.
The app automatically asks if the de-
vice has already been mounted or not.
If the device has not yet been moun-
ted, the installation wizard starts in the
app with a step-by-step instruction for
mounting on the door lock cylinder.
The installation instructions can also
be found in section
on page 25).
As soon as the installation has been
completed, the pairing process is con-
tinued and the settings of the installati-
on position are queried:
• Wait until paring is completed.
• If pairing was successful, the LED
(C) lights up green. The device is
now ready for use.
• If the LED lights up red, please try
again.
• Allocate the device to a room and
give the device a name.
7 Mounting
Please read this entire section
before starting to mount the de-
vice.
As soon as you put the door lock drive
into operation for the first time, a que-
ry opens in the app during the paring
process asking whether the installation
wizard should be started. The installa-
(see „7 Mounting"
tion wizard will guide you through the
single installation steps, as illustrated
below.
Your door lock has to be installed
on the cylinder lock using the black
mounting plate while the key is inser-
ted. Please also refer to the informati-
on in section (see „6.1 Requirements on
the door and the lock cylinder" on page
22).
You can open the installation
wizard at any time via the
Homematic IP app.
Please note that the function
"open" has to be carried out after
the initial start-up to make sure
that the lock actuator can allocate
its current position.
25